Option

Description

Transfer between offsets

Enter the offsets between which points should be transferred. If you wish to transfer one particular point by offset, say at 1.5, then enter the offsets as slightly smaller than and slightly larger than the desired value.

Using this example you would enter the offsets as 1.49 and 1.51. This will overcome the effect of floating point rounding where a point such as 1.5 is actually stored as 1.499999. Only available if processing by offsets.

Offsets to the left of the centreline should be entered as negative values.

Transfer between point codes

Enter the PLCs between which points should be transferred. PLCs are exact codes so floating point rounding plays no part. Only available if processing by point codes.

Points to the left of the centreline should be entered as negative values.

Back Button

Click to go back to the Process Details.

Finish Button

Click to accept the current entries.

Cancel Button

Click to cancel the function.