Option

Description

Display contours

Select this checkbox to enable contour display.

Contour details

Quick or Generated

Select either the Quick option to display contours from polygons, or the Generated option to display contours as generated by the Contours from Lines or DTM Contour functions.

Surface

Select the surface for which contours must be displayed. For generated contours, the list will contain only the surfaces that have had Contours from Lines already performed on it.

Smoothed

If you have selected the Generated option you can also select to have the contours smoothed. This will apply a Bezier curve to the contour. This smoothing can, however, sometimes introduce anomalies such as contours crossing each other. Use with caution. It is also far slower than displaying un-smoothed contours.

Show

This option is only enabled when the Generated radio button is selected, and applies to whichever surface is selected in the Surface option. Each surface with the Show checkbox selected will have the generated contours switched on.

Datum

Enter the rounding factor for contour elevations. Contours that are a multiple of this value will be displayed. Only available if the Quick option is selected.

Min. Height

Enter the minimum height for the displayed contours. A value of 0 implies no minimum. Only available if the Generated option is selected.

Max. Height

Enter the maximum height for the displayed contours. A value of 0 implies no maximum. Only available if the Generated option is selected.

Contour display

Contour Interval, Pen and Linetype

Enter the height interval at which to display contours, the pen to be used to draw the contour lines, and the line type in which to draw the contours.

Highlight, Interval, Pen and Linetype

Select this checkbox to display highlighted contours. Enter the height interval at which to display highlighted contours, the pen to be used to draw the highlighted contours, and the line type in which to draw the highlighted contours.

Label, Interval and Pen

Select this checkbox to label contours. Enter the height interval at which to display labels, and the pen to be used to label the contours. Only applicable to Generated contours.

Transparent labels

Select this checkbox to have the label text superimposed on the contour

Txt hgt

Enter the height of contour labels in mm. Only applicable to Generated contours.

 Decimals

Enter the number of decimal places for contour labels. Only applicable to Generated contours.

Label spacing

Specify the interval, in metres, along the contour line at which contour labels should be displayed. Only applicable to Generated contours. To turn off interval labelling along contour lines, set the spacing to 0.000.

 Contours labelled downhill

Select this checkbox to have contour labels generated such that the labels are oriented to be read when facing downhill. Normally contour labels are oriented to be read when facing uphill.

Second surface

Display contours

Select this checkbox to have contours displayed for an additional surface. Only available for Quick contours.

Pen

Click this button to select the colour in which these contours should be displayed. Only available for Quick contours.

Surface

Select the surface for which the second set of contours must be displayed. Only available for Quick contours.

Difference contour display

Above Pen and Linetype

Select the Pen and Linetype in which to display difference contours above the datum contour. Only applicable when Generated is selected and the stored contour file was created from a grid generated by the DTM Ground/Design Difference function.

Datum Pen and Linetype

Select the Pen and Linetype in which to display the datum contour. Only applicable when Generated is selected and the stored contour file was created from a grid generated by the DTM Ground/Design Difference function.

Below Pen and Linetype

Select the Pen and Linetype in which to display difference contours below the datum contour. Only applicable when Generated is selected and the stored contour file was created from a grid generated by the DTM Ground/Design Difference function.