Option

Description

Cross Section Setup

Chainage Range

Enter the start and end chainages for which cross-sections should be plotted.

Offset limits

Enter the limits left and right of the centre line within which cross-section information should be extracted. Note that offsets left of the centre line must be entered as a negative value.

Section Interval (m)

Specify the interval between cross-sections. For instance, you can specify an interval of 20m even though the road has been coordinated at 5m intervals.

Vertical scale

Enter the vertical scale of the plotted cross-section.

Horizontal scale

Enter the horizontal scale of the plotted cross-section.

Plot all roads

Select this checkbox to plot the cross-sections of all the roads in the project.

Plot Skew Sections only

Select this checkbox to only plot cross-sections with non-zero skew angles.

Auto scroll to next page

Select this checkbox to have new plots automatically generated if the cross-sections in the selected chainage range do not fit on the first sheet.

Crossing Settings button

Click to display the Crossing Services options, and to specify which crossing services to display on the long section.

Display Crossing pipes

Select this checkbox to display crossing pipes on cross-sections. The Crossing Services will be displayed when this checkbox is selected.

Table Data

Plot column

Select whether this cross-section line should be plotted (Yes) or not (No). Right-click on the cell to toggle.

Pen column

Enter the pen number to be used for this cross-section line. Right-click on the cell to access the pen selection.

LT column

Select the line type to be used for this cross-section line.

Layer column

Select the road layer from which this cross-section line should be extracted. Right-click on the cell for a list of road layers.

Back Button

Click to return to the previous page.

Finish Button

Click to accept the current entries.

Cancel Button

Click to cancel the function.