The selected roads will be listed under the Intersecting Road and Main Road sections. Refer to the junction schematic.
If you want to change these you can select the roads from the dropdown lists. The top list is the intersecting road and the bottom list is the road it intersects with.
Option
|
Description |
Coordination |
|
Interval |
The strings along the bell-mouths will be coordinated using this interval. |
Point Prefix |
Each bell-mouth point will have this prefix when you translate the junction to a DTM surface, or when you opt to display the junction list during plan plotting. |
Divider Islands |
|
Drive on: |
Drive on the left-hand or right-hand side of the road. This has an influence on which direction the tapering will be applied. |
Minimum area (sq m) |
Enter the minimum area of islands to be added. If the island is smaller than the minimum, it will not be added to the junction. |
Template for curves |
This template will be used at the bell-mouths and will default to the template used at the intersecting road. |